Where does a monogram go on a shirt cuff, and how big should it be?

Across, up and height figures for a dress shirt cuff from three placement guides and four maker tutorials side by side, why the same 1 3/8 inch figure lands in two different places, and the collar, placket and pocket spots for the rest of the shirt.

Updated 7 min read Reviewed against our editorial standards

Quick answer

Put it on the left cuff with the bottom of the letters 1/4 inch above the cuff edge, facing away from the wearer. Across, use one of two published figures: 1 3/8 inches from the buttonhole (Embroidery Library), or 1 to 1.25 inches from the cuff's center fold toward the buttonhole (Embrilliance). Make three equal letters 3/8 inch (about 9.5 mm) tall.

On this page
  1. Cuff figures side by side
  2. One number, two reference points
  3. How big the letters should be
  4. Which cuff, and which way up
  5. Other places on a dress shirt
  6. Mark and stitch it, step by step
  7. Where these numbers stop applying

A shirt cuff monogram goes on the left cuff, with the bottom of the letters 1/4 inch above the cuff edge and the letters facing away from the wearer. Three equal letters are 3/8 inch (about 9.5 mm) tall; with a larger middle letter, up to 3/4 inch overall. Across the cuff, the guides give one of two positions: 1 3/8 inches from the buttonhole, or 1 to 1.25 inches from the center of the cuff toward the buttonhole. Both are published, and they are not the same spot. The mistake is to take one guide's number and measure it from the other guide's starting point.

Cuff figures side by side

Every source below is for a barrel cuff, the kind that closes with a button. They agree on the height above the edge; they disagree on where you measure across from.

Shirt cuff monogram placement and height, by source
SourceAcross the cuffUp from the cuff edgeLetter height
Embroidery Library (adult)1 3/8 in to the right of the buttonhole1/4 inNot given
Embroidery Library (children)1 in, or 3/4 in for the smallest sizes1/4 inNot given
Baby LockTemplate 1 3/8 in to the right of the buttonhole1/4 inNot given; letters shrunk to fit
EmbrillianceTop and center of the wrist: 1 to 1.25 in from the center toward the buttonholeBottom very near the cuff's top stitching3/8 in
Machine Embroidery GeekAbout 3 in from the inside edge of the buttonholeClose to the bottom edge3/8 to 3/4 in (used 3/8 in, 10 mm)
Sewing Machine Fun1 3/8 in toward the buttonhole with the cuff folded in half1/4 to 1/2 inNo more than 0.35 in, or 0.75 in with a larger middle letter
WeAllSewTape guide about 1/2 in from the buttonholeTape guide along the bottom edge0.7 in (a single modern monogram)

Embroidery Library and Baby Lock both say the monogram should face away from the wearer. Sewing Machine Fun's height limits are Joyce Jagger's, and its 1/4 to 1/2 inch range is the one it quotes from Wilcom. WeAllSew does not say which part of the design meets its tape, so that row is a method, not a measurement.

One number, two reference points

The 1 3/8 inch figure is Embroidery Library's, and it is measured from the buttonhole. Baby Lock's monogrammed shirt project uses the same figure the same way: it places the template 1 3/8 inches to the right of the buttonhole and lines the needle up over the template's cross marks.

Sewing Machine Fun restates that figure as 1 3/8 inches "toward the buttonhole when the cuff is folded in half". That is measured from the center fold, which is Embrilliance's starting point, not Embroidery Library's. Embrilliance gives 1 to 1.25 inches from the center toward the buttonhole, so the restated figure lands just past Embrilliance's range, not where Embroidery Library put it.

An unbuttoned barrel cuff laid flat with the buttonhole at the left end and a dashed center fold. Monogram A is centered 1 3/8 inches from the buttonhole; monogram B is centered 1 to 1.25 inches from the center fold toward the buttonhole. Both sit 1/4 inch above the cuff edge.
Position A (Embroidery Library, Baby Lock) is measured from the buttonhole and sits near the closure. Position B (Embrilliance) is measured from the center fold and sits nearer the middle of the cuff, over the top of the wrist. Both put the bottom of the letters 1/4 inch above the cuff edge. Schematic, not to scale.

Which position to use

Use position B, 1 to 1.25 inches from the center fold, unless you want the monogram right beside the closure. Three sources point to the top of the wrist. Embrilliance names it outright: "Top and center of wrist". Machine Embroidery Geek found its spot by marking a cuff while the shirt was being worn and landed on about 3 inches from the inside edge of the buttonhole, well along the cuff from Embroidery Library's figure. Sewing Machine Fun says monograms usually sit above the center of the wrist and that this is what Brooks Brothers and Jos. A. Bank do. It also calls the location "somewhat preference": position A is a published choice, not a mistake. Mixing the two is the mistake.

Position B also has a fixed starting point. The guides do not say which end of the buttonhole they measure from; if you use position A, measure from the end nearer the cuff center, and use the same end on every shirt of a set.

How big the letters should be

For three letters of equal size, use 3/8 inch (about 9.5 mm). That is Embrilliance's figure, the 3/8 inch Sewing Machine Fun quotes from Deborah Jones of AnntheGran, and the 10 mm Machine Embroidery Geek stitched. Joyce Jagger's "no more than .35 inch" is the same size to within a millimeter. Machine Embroidery Geek's upper figure of 3/4 inch matches Joyce Jagger's limit for a monogram with a larger middle letter, so treat 3/4 inch as the ceiling for that style, not for three equal letters.

The letter order follows the style. Sewing Machine Fun puts equal letters in first, middle, last order, and with a larger middle letter, as first, last, middle: the surname initial goes large in the center. WeAllSew's 0.7 inch is a single stylized monogram, not three letters.

3/8 inch is comfortably above the floor for readable capitals with 40 wt thread, which our lettering guide puts at about 6 mm (1/4 inch) on smooth fabric. At this size the risk is the font: Sewing Machine Fun says a cuff monogram needs a font "digitized for small sizes", and recommends block and serif styles over script. Going down to 1/4 inch puts you at that floor, where small lettering problems start.

Which cuff, and which way up

The left cuff is the usual one: Sewing Machine Fun calls it "the most frequently monogrammed", and Machine Embroidery Geek says either cuff works. "Face away from the wearer", in Embroidery Library's words, means the letters read the right way for someone looking at the wearer and upside down for the wearer glancing at their own wrist. With the cuff laid flat outside face up, that puts the bottom of the letters toward the cuff edge, the hand side.

Other places on a dress shirt

Embrilliance's guide covers the other monogram spots on a shirt:

Dress shirt monogram positions other than the cuff (Embrilliance)
SpotWhere it goesLetter height
CollarLeft side, above the buttonhole if there is one3/8 in
PlacketCentered between the 2nd and 3rd buttonholes1/4 to 3/8 in
Chest pocketCentered on the pocket hem, top of the design 1/4 in below the top of the pocket; shift right if the pocket has a center button1/4 to 3/8 in
Short sleeveCentered 1/4 to 1/2 in above the sleeve hem1/4 to 3/8 in

A logo on a shirt with no pocket is a left chest job with its own measurements; see left chest logo placement. On a sweatshirt or hoodie with a ribbed cuff and no button, the cuff figure is about 1 inch above the rib, in hoodie and sweatshirt placement.

Mark and stitch it, step by step

  1. Unbutton the cuff and lay it flat, outside face up, buttonhole end on the left.
  2. Mark the center line across. For position B, fold the cuff end to end, crease the fold, and measure 1 to 1.25 inches toward the buttonhole. For position A, measure 1 3/8 inches from the buttonhole. Mark a vertical line there.
  3. Mark the baseline 1/4 inch above the cuff edge. Where the two lines meet is the bottom center of the monogram; in software, move the design center up by half the letter height.
  4. Float it on sticky stabilizer. Machine Embroidery Geek hoops adhesive-backed tearaway, draws center lines on it and presses the cuff on; WeAllSew scores Stabil Stick tearaway, and Baby Lock sprays temporary adhesive on Tear-Away Soft in a 100 x 100 mm hoop. Sewing Machine Fun did best with the cuff hooped in a 1.5 x 2 inch hoop. See floating and adhesives and fusibles, and keep the rest of the sleeve rolled out of the needle's path.
  5. Thread and needle. Both tutorials use a 75/11 embroidery needle with 40 wt thread. Sewing Machine Fun finds 60 wt cleaner at this size; pair it with a 70/10 or 65/9, as thread weights and embroidery needles explain. Machine Embroidery Geek finds a topper unnecessary on a shirt cuff.

Where these numbers stop applying

  • French cuffs. None of the guides we checked gives a figure for a folded, linked cuff; the figures here are for barrel cuffs.
  • Cuffs with two buttonholes or two buttons. The guides do not address them. Position B, measured from the center fold, does not depend on which buttonhole is in use.
  • Children's shirts. Embroidery Library shortens the distance from the buttonhole to 1 inch or 3/4 inch on smaller shirts.
  • Linens and towels. Monograms there are inches tall, not fractions of an inch; see towel monogram size and placement.

If a cuff monogram is placed right and still puckers or shifts, the cause is stabilizer or hooping, not placement. Change one thing per test, as the Stitch-Out Tuning Method sets out. Other monogram decisions are on the projects guide.

Frequently asked questions

Which cuff does a monogram go on?

Usually the left cuff. Sewing Machine Fun calls it the most frequently monogrammed one; either cuff works if the wearer prefers the right.

How far from the buttonhole does a cuff monogram go?

Embroidery Library puts it 1 3/8 inches to the right of the buttonhole. Embrilliance measures from the cuff's center fold instead: 1 to 1.25 inches toward the buttonhole. Measure each figure from its own starting point; the two give different positions.

How tall should a shirt cuff monogram be?

3/8 inch (about 9.5 mm) for three equal letters. With a larger middle letter, up to 3/4 inch overall. Below 1/4 inch you reach the floor for readable lettering with 40 wt thread.

Which way should a cuff monogram face?

Away from the wearer: upright for someone looking at the wearer, upside down for the wearer looking at their own wrist. On the flat cuff, the bottom of the letters points to the cuff edge.

How far above the cuff edge should the monogram be?

The bottom of the letters 1/4 inch above the cuff edge, which is Embroidery Library's and Baby Lock's figure. Embrilliance says very near the cuff's top stitching.

Sources and further reading

Found something wrong or out of date? Tell us and we will fix it.